Vimar Elvox 3530 Instrucciones Instalador página 5

2. TYPE 3532 USED WITH TYPE 3530 AND A TELEPHONE
Using type 3530 it is possible to connect the telephone interface to a fixed or cordless telephone without need of using a tele-
phone switchboard. In this case the telephone connected is used only to answer the telephone calls.
1
2
3
The telephone number to be programmed on the interface type 3531/3532/3533 can be:
Telephone number
0
0 # < time in seconds > #
To call the interface it is enough to engage the line from the telephone:
To program type 3531/3532/3533 see instructions concerning the same article. Usually the telephone number programming is
made in the following way:
. Raise the handset of the telephone connected to type 3530 and wait for the double answer tone.
. Digit on the telephone the following sequence: *#1234#010#** .
. If you want to enter a sequence of tone different from 60s: *#1234#010*#T*##** where T corresponds to the time in seconds.
Generally a ring tone lasts nearly 5 seconds, therefore, for example, to make the telephone ring with three tones you should
enter a time equal to T = 15.
Example:
To program the first telephone interface call so that it calls the telephone connected and that the same continues to ring for 15
seconds, enter the following sequence:
EN
Art353x
To the interphone
All' impianto
installation
citofonico
Note: Interface type 3530 must be powered at 230V ~ - 50 Hz.
Description
To be used to call the telephone. The telephone ringing tones have a preset
dwell time of 60 seconds.
To be used to call the telephone. The telephone ringing tones have a preset
dwell time indicated in the number < time in seconds >.
Mains
Art3530
line
Interfac
5