Installation; Preparation; Fitting The Legs (350Cb And 360Cb Only); Fitting The Handle Holder - Dovre 350CB Instrucciones De Instalacion Y Uso

Model 350CB3/WB
Features of model 350CB3/WB
This model has the same features as model 350CB3.
The appliance is installed with a log compartment
that is shut off by a door.

Installation

Preparation

Please check the appliance for damage caused
during transport or any damage or defects
immediately after delivery.
If you detect damage caused during transport
or any other damage or defects, do not use the
appliance and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire basket, ash pan, fire grate) from the
appliance before you start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door.
2. Remove the fire-resistant inner plates.
Cast iron inner plates protect the combustion
chamber and dissipate heat to the
environment.
Fitting the legs (350CB and
360CB only)
If desired, you can fit the appliance with height-
adjustable legs. Fit the legs to the appliance; see the
following figure.
8
1. Tilt the appliance on its back.
2. Fit the height-adjustable legs (A) to the desired
height using the bolts M6 (C) and washer (B)
provided.
3. Fit the appliance on the newly-fitted legs in the
original position.

Fitting the handle holder

Fit the handle holder provided (A) to the base of the
appliance using the washer (B) and the bolt M8 (C);
see the following figure.
Subject to change because of technical improvements