Burning Wood - Dovre 350CB Instrucciones De Instalacion Y Uso

1. Stack two layers of medium sized logs crosswise.
2. Stack two layers of kindling crosswise on top of
the logs.
3. Place a firelighter cube in the lower layer of
kindling and light the cube according to the
instructions on the packaging.
4. Close the door of the appliance and open the
primary air inlet and the secondary air inlet of the
appliance. The primary air inlet is open if the
operating knob has been pulled out. The
secondary air inlet is open if air slider (C) has been
slid left; see following figure.
5. Let this fire develop into a good blaze until there is
glowing bed of charcoal. You can then add fuel
and adjust the appliance, see the chapter "Stoking
with wood".

Burning wood

After you have followed the instructions for lighting :
12
1. Slowly open the door of the appliance.
2. Spread out the charcoal bed evenly across the
bottom of the fire compartment.
3. Stack a few logs on the charcoal bed.
Open stacking
If the logs are stacked openly, the wood will burn
quickly as the oxygen can reach each log easily. If
you want to use the stove for a short while, make an
open stack.
Compact stacking
If the logs are stacked tightly, the wood will burn more
slowly as the oxygen can only reach some logs
easily. If you want to burn wood for a longer period,
make a compact stack.
Subject to change because of technical improvements