Cooper Lighting HALO RL560 Serie Instrucciones
Cooper Lighting HALO RL560 Serie Instrucciones

Cooper Lighting HALO RL560 Serie Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

®
HALO
RL560 Series
RL560WH, RL560WH-R, RL560WH-C
RL560SN, RL560SN-R, RL560SN-C
ENGLISH
ITEMS REQUIRED
(Purchase separately)
Screwdriver
Gloves (if using friction blades)
IMPORTANT SAFETY INSTRUCTIONS
When using product, basic precautions should always be followed, including the following:
Heed all warnings, including below warnings AND those included on product.
HALO
recessed luminaires (fixtures) are designed to meet the latest NEC
®
requirements and are UL/cUL listed in full compliance with UL 1598. Before
attempting installation of any recessed lighting luminaire check your local
electrical code. This code sets the wiring standards for your locality and should
be carefully studied before starting.
WARNING
Read and follow these instructions.
Risk of fire. MINIMUM 90° C SUPPLY CONDUCTORS. If uncertain, consult an electrician.
Risk of electric shock. To avoid possible electrical shock, be sure that power supply is
turned off at fuse box or circuit breaker before installing or servicing fixture.
CAUTION
Connect fixture to a 120 volt, 60 Hz power source. Any other connection voids
the warranty.
Fixture should be installed by persons with experience in household wiring or by a
qualified electrician. The electrical system, and the method of electrically connecting
the fixture to it, must be in accordance with the National Electrical Code and local
building codes.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
SAVE THESE INSTRUCTIONS AND WARNINGS.
HOUSINGS
The RL560 series comes with a dedicated LED connector for California Title 24
Compliance and is UL Listed for installation into Halo
and H750TCP series, H2750ICAT, H550ICAT, H550RICAT recessed LED housings.
The RL560 series also includes an E26 Edison screw base adapter to accommodate
standard screw base housings. The RL560 is UL Listed and Classified for retrofit in the
following housings:
Questions? /¿Preguntas ?/Questions ? 1-800-334-6871 ConsumerProducts@cooperlighting.com
PACKAGING CONTENTS/CONTENIDO DEL PAQUETE
A. LED module and connector
Módulo LED y conector
Module à DEL et connecteur
H750ICAT, H750R series, H750T
®
Instruction Manual/Instrucciones/Directives
B. #8-32 Self tapping screw
Tornillo mecánico #8-32
Vis de mécanique #8-32
UL Listed
- HALO
®
: H7ICAT, H7ICT, H7T, H7ICATNB, H7ICTNB, H7TNB, H7UICAT, H7UICT, H7TCP,
H7RICAT, H7RICT, H7RT, H27ICAT, H27ICT, H27T, H27RICAT, H27RICT,
H27RT, H5ICAT, H5RICAT, H5T, H5RT, H5TM, H25ICAT
- HALO
LED Retrofit: ML7BXRFK, ML7E26RFK
®
- ALL-PRO
: EI700, EI700AT, EI700ATNB,EI700U, EI700UAT, EI700NB,EI700R,
EI700RAT, ET700, ET700R, EI2700, EI2700AT, ET2700,EI2700R,
ET2700R, EI500AT, ET500, EI500RAT, ET500R
UL Classified
- Juno: IC22, IC22R, IC22W, IC22S, IC23, IC23W, IC21, IC21R, IC2, TC2, TC2R, IC20,
IC20R, IC25, IC25R, IC25W, IC25S, TC20, TC20R
- Lightolier: 1104ICS*, 1104ICR*, 1104SIC*
1004SIC*
, 1004SICR*
1104ICX - Requires installation of Halo ML7RAB retrofit adapter band
accessory.
- Capri: CR1, PR1, QL1, R9ASIC, R5*
- Progress: P87-AT*, P86TG
- Lithonia: L7X, L7XP
- Thomas: PS1, R9ASIC/PS9RM
- Prescolite: IBXS
- Commercial Electric: C7ICA (H3), H18
- Elco: (HL7ICA) EL7ICA
* Requires replacement of torsion springs with friction clips (order clips separately:
RL56CLIP).
Shallow Lightolier housings require can to be raised to highest position and two
tabs inside socket cup to be bent outward.
DIMMING
The Halo LED luminaire can be dimmed, however updates in dimmer technology and special
conditions may apply depending on the dimmer type being used. For the latest information
regarding dimmers for use with this LED luminaire, please see the Halo LED Dimming
Reference Sheet at www.cooperlighting.com. In addition, you may wish to consult the dimmer
manufacturer for their latest dimmer configurations and product information.
GROUND WIRE ATTACHMENT
NOTE: Ground wire must be securely installed to the
housing. Three connection methods shown below.
1. For ground connection from LED module to housing,
use provided green ground wire (factory installed)
as shown in (Fig. 1).
1
C. #8-32 Hex Nut
Tuerca hexagonal #8-32
Écrou hexagonal #8-32
, 1104SICR*
, 1004ICS*, 1004ICR*,
Fig. 1
Ground wire

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Cooper Lighting HALO RL560 Serie

  • Página 1 ® HALO Instruction Manual/Instrucciones/Directives Questions? /¿Preguntas ?/Questions ? 1-800-334-6871 ConsumerProducts@cooperlighting.com PACKAGING CONTENTS/CONTENIDO DEL PAQUETE B. #8-32 Self tapping screw C. #8-32 Hex Nut A. LED module and connector Módulo LED y conector Tornillo mecánico #8-32 Tuerca hexagonal #8-32 Module à DEL et connecteur Vis de mécanique #8-32 Écrou hexagonal #8-32 RL560 Series...
  • Página 2 Fig. 7 2. Connect other end of ground wire to housing. For 5” housings with torsion spring receiving Connection to housing may vary depending brackets: 5" Housings using Torsion on model. Three connection methods are Spring Bracket NOTE: Module ships with torsion spring pre-installed described below.
  • Página 3: Artículos Necesarios

    El RL560 también incluye un adaptador de base Edison para adaptar This warranty does not apply to Cooper Lighting products that have been altered or repaired or alojamientos ICAT de base con rosca estándar. El RL560 está homologado y clasificado that have been subjected to neglect, abuse, misuse or accident (including shipping damages).
  • Página 4: Regulador De Intensidad De Luz

    REGULADOR DE INTENSIDAD DE LUZ PARA DETERMINAR CUÁL MÉTODO DE FIJACIÓN USAR El sistema de iluminación LED de Halo se pueden regular, sin embargo, cambios en la tecnología de regulador y las condiciones especiales pueden aplicarse dependiendo del Fig. 5 Para alojamientos de 6”...
  • Página 5 El daño evidente y oculto que se provoque durante el transporte se debe informar de inmediato al transportista que realiza la entrega y se debe presentar un reclamo. La reproducción de este documento sin la aprobación previa por escrito de Cooper Lighting, LLC está estrictamente INSTALACIÓN EN ALOJAMIENTOS prohibida.
  • Página 6 GRADATION DE LUMIÈRE FRANÇAIS Le luminaire DEL Halo peut être atténuée, toutefois mises à jour en matière de technologie et gradateur conditions spéciales peuvent s’appliquer selon le type gradateur utilisé. Pour les ARTICLES NÉCESSAIRES dernières informations concernant les gradateurs pour une utilisation avec ce luminaire LED, s’il vous plaît voir le Halo LED gradation Fiche de référence à...
  • Página 7: Déterminer Quelle Méthode De Fixation Utiliser

    DÉTERMINER QUELLE MÉTHODE DE INSTALLATION DE POSTCÂBLAGE DANS FIXATION UTILISER LE BOITIER ENCASTRÉ À BASE VISSÉE EDISON E26 Pour les boîtiers de 6 po avec support de ressort de REMARQUE : Vérifiez que le boîtier est compatible torsion: Fig. 5 Fig.
  • Página 8: Garantie Limitée De 5 Ans

    être signalé immédiatement au transporteur effectuant la livraison et une réclamation doit être adressée à ce dernier. La reproduction de ce document est strictement interdite sans l’autorisation préalable par écrit de Cooper Lighting, LLC. Pour assistance, appelez le 1-800-334-6871 ou envoyez-nous un courriel à consumerproducts@cooperlighting.com.

Este manual también es adecuado para:

Halo rl560whHalo rl560wh-rHalo rl560wh-cHalo rl560snHalo rl560sn-rHalo rl560sn-c

Tabla de contenido