Cooper Lighting RSWPD Instrucciones De Instalación

Installation Instructions
RSWPD - Outdoor Sensor Extender/Multiplier
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be
performed by a qualified electrician. This product must be installed in accordance with the applicable installation code
by a person familiar with the construction and operation of the product and hazards involved. For continued protection
against shock hazard replace all covers and guards after field wiring is completed.
Risk of Fire and Electric Shock- Before installing or performing any service, the power MUST be turned OFF.
All installations should be in compliance with the National Electric Code and all state and local codes.
Risk of Burn- Disconnect power and allow product to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise
from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing product. Retain for future reference.
NOTICE: Product may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions subject to change without notice.
ATTENTION Receiving Department: Note actual product description of any shortage or noticeable damage on delivery receipt.
File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be filed within 15 days of delivery.
All damaged material, complete with original packing must be retained.
NOTE: These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to
provide directions for meeting every possible contingency during installation, operation or maintenance. When additional information is
desired to satisfy a problem not covered sufficiently for user's purpose, please contact your nearest representative.
NOTE: This fixture has been shipped complete with one of several mounting options. Please follow the installation instructions specific
to the catalog part that you ordered.
NOTE: Care must be taken not to set fixture down on optical lenses or lift the fixture in the lens area.
NOTE: Specifications and dimensions subject to change without notice.
NOTICE: All new wiring must be fully verified before applying power.
Do not mount luminaire within 6" of a combustible surface.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances. Proper
grounding is required to insure personal safety. Carefully observe grounding procedure under installation section.
APPLICATIONS: The remote sensor housing incorporates a WaveLinx wireless sensor available with two alternate control options:
OPTION 1: Control Multiplier (CM) is a Wavelinx controlled relay to service an 8-amp to 16-amp load (depending on voltage). Power
monitoring is not available for this option. Dimming control is not available.
OPTION 2: Wireless Extender (WE) is a remote sensor housing that is a Wavelinx repeater or "hopper" . Line in power will only need to
be connected for the sensor to operate.
WaveLinx Wireless
WARNING