To Install Infant Car Seat (Sold Separately) - Schwinn Interval Jogger Manual De Usuario

5

To Install Infant Car Seat (Sold separately)

WARNING:
To avoid serious injury:
• Use ONLY IC178, IC181, IC201, IC203, IC205, IC206,
IC207, IC208, IC210, IC211, IC212, IC217, IC218, IC219,
IC220, IC224, IC226, IC228, IC229, IC230, IC231, IC233,
IC234, IC240, IC244, IC250, IC251, IC252, IC258, IC259,
IC261, IC263, IC267, IC279, IC280, IC305, 22036, 22056,
22326 infant car seats with this stroller.
• Please refer to the manufacturer's instructions for the use
of your infant car seat.
• ALWAYS use child's tray when car seat is installed.
• NEVER use child tray cup holder when car seat is attached to
stroller.
Stroller may tip over and injure infant.
• ALWAYS install car seat facing to the rear of the stroller.
• ALWAYS use the restraint system in the car seat.
13
❶ Recline seat back to lowest position.
Figure 5.1 Close canopy.
Car seat must be positioned so child faces the stroller
handle.
Position car seat over the stroller. Touch rear flat vertical
surface of car seat A against rear vertical surface of the child tray
B. Lower straight down into stroller and push down on handle. Car
seat will click into place when fully nested. Figures 5.2 and 5.3
Figure 5.2
4
Figure 5.1
Figure 5.3
A
B