Attach The Front Wheel - Schwinn Interval Jogger Manual De Usuario

ATTACH THE FRONT WHEEL

❶ Loosen the locking nut by hand. Figure 3.6
❷ Align wheel axle with front wheel forks and insert wheel. Figure
3.7 Finger tighten the locking nut located on one side of the axle.
❸ Lock axle in place by pressing the quick release lever toward the
wheel Figure 3.8, until it is secured against the frame.
NOTE: It may be difficult to press the quick release lever against
the frame. If so, release the lever, loosen locking nut one or two
turns and try again.
TIRE PRESSURE NOTE: inflate tire pressure to 25-psi. Use a
manual bike pump to inflate tires. NEVER use an air compressor
to fill tires with air (like those used at gas stations).
Remove Front Wheel - Pull quick release lever away from wheel.
1
Fork Fork
Locking
Nut
Quick
Release
Lever
Figure 3.6
2
Figure 3.7
Quick
3
Release
Lever
Figure 3.8
6