Panasonic EY46A5 Manual De Instrucciones página 10

III.
ASSEMBLY
EN
CAUTION
DE
• When attaching or removing blades,
disconnect battery pack from main unit.
FR
Attaching Blade
IT
1. Raise the blade release lever and pull
out the fi xing bolt. [Fig.1]
NL
• Make sure that the blade release
lever is in front of the main unit and
parallel to the main unit.
ES
Raise the blade release lever.
DA
Since the operation becomes heavy
from here, fi rmly hold down the
SV blade release lever unit it is parallel
to the main unit.
NO
Remove the fi xing bolt.
NOTE:
FI
• If it is diffi cult to pull out, grasp the
fi xing bolt and rattle left and right.
TR
2. With the blade mounting section facing
up, insert the blade and fi xing bolt into
PL
the blade mounting section in order.
[Fig.2]
CS
• Align the hole of the blade with the
convex part of the blade mounting
part and attach it.
HU
• Insert the fi xing bolt fi rmly all the way
in.
3. Fix the blade by tilting the blade
release lever to the switch side. [Fig.3]
Firmly return the lever to its original
position.
Make sure the blade is secure.
CAUTION
• Be careful not to get your fi ngers caught.
Removing Blade
1. Raise the blade release lever.
[Fig.1
2. Remove the fi xing bolt and blade in this
order. [Fig.1
CAUTION
• Do not touch the blade immediately after
operation. It may be hot and could burn
your skin.
]
]
• Grab the fi xing bolt and rattle it from side
to side.
If it still does not come out, insert a
fl athead screwdriver between the fi xing
bolt and blade mounting part and pry it
out.
Attaching or Removing
Battery pack
1. To attach the battery pack:
[Fig.4 ]
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks into
position.
2. To remove the battery pack:
[Fig.4 ]
Push the button and slide the battery
pack forward.
IV.
OPERATION
[Main unit]
NOTE:
• Be aware that this tool is always in an
operating condition, since it does not
have to be plugged into an electrical
outlet.
Power switch operation
CAUTION
• Before inserting the battery pack into the
tool, always make sure that the power
switch operates properly and returns to
the "OFF" position when the rear of the
power switch is depressed.
• Power switch can be locked in "ON"
position. Stay alert when locking tool in
"ON" position and grasp the tool fi rmly.
1. To start operation, press and slide the
power switch toward the "ON" position.
[Fig.5 ]
• Lightly attach the blade to the target
and move the main unit in the cutting
direction.
• To stop the tool, press the rear of the
power switch, then it returns to the
"OFF" position. [Fig.6]
- 10 -