Frequency Channel; Trigger Group Modes - Elinchrom EL-Skyport Instrucciones De Funcionamiento

Frequency Channel

Note:
Transmitter and the corresponding Transceivers RX or Universal Receivers must have
the same frequency channel setting !
Frequency
Channel
1 (default)
2
3
4
5
6
7
8
Note :
After setting, switch Transceiver RX OFF and ON again to activate the new frequency channel change.

Trigger Group Modes

The EL-Skyport Transceiver RX can be triggered by the EL-Skyport Transmitter in the
following modes:
1. Groups (1 to 4) sets and triggers flash units in different "Groups"
è only Flash Units with the selected Group are triggerd by transmitter
2. ALL Transmitter Mode is set to ALL
è all EL-Skyport Receiver Groups are triggerd by the Transmitter
Slide Button configuration
1 2
Off Off
On Off
Off On
On On
Off Off
On Off
Off On
On On
Trigger
Frequency
3
/ Mhz
Off 2456
Off 2458
Off 2460
Off 2462
On 2469
On 2471
On 2473
On 2475
Remote
Frequency
/ Mhz
2448
2450
2452
2454
2461
2463
2465
2467
5