D-Link DSR-150 Guia De Instalacion página 34

Item Function
A USB port (1)
B Reset button
Power on/off
C
button
D Power jack
Table 2: DSR-150 Side Button Description
DSR-150 back view: device interfaces
A
Figure 3: DSR-150 Back View
Item Function
A Fast It connects Ethernet devices, such
Ethernet as computers, switches and hubs
LAN port
(1-8)
B Fast One auto MDI/MDIX WAN port used
Ethernet to connect the cable or DSL modem
WAN port for Internet.
(1)
C Console It is used to access Command Line
port (1) Interface (CLI) via RJ45-to-DB9
console Cable.
Table 3: DSR-150 Back Interface Description
DSR-150 Default Interface Settings:
Ethernet Interface
IP Address
Interface Type
LAN (1-8) Static IP 192.168.10.1 Enabled
WLAN
WAN DHCP 0.0.0.0
client
Table 4: Default Interfaces Settings
Description
It adheres to USB 2.0 standard
and is also compatible to USB
1.1. Now we support below
features through this USB port:
1. Flash Disk or Hard Disk for
files sharing.
2. Printers for printer sharing
Long press to reset the device
Push down this button to turn on
the device
DC power jack
B C
Description
Web-Based DHCP
Management Server
Enabled
Disabled Disabled
Note: D-Link Services Routers only allow Web
GUI access from LAN and WLAN interfaces by
default for security reason.
Installing and Connecting the
Device
This chapter describes how to connect cables and
power to the device.
Before You Begin
Observe the following precautions to help prevent
shutdowns, equipment failures and injuries:
- Before installation, always check that the power
supply is disconnected.
- Ensure that the room in which you operate the
device has adequate air circulation and that
the room temperature does NOT exceed 40˚C
(104˚F).
- Allow 1 meter (3 feet) of clear space to the front
and back of the device.
- Do NOT place the device in an equipment rack
frame that blocks the air vents on the sides of
the chassis. Ensure that enclosed racks have
fans and louvered sides.
- Before installation, please correct these
hazardous conditions: moist or wet floors,
leaks, ungrounded or frayed power cables, or
missing safety grounds.
Connecting Power and Turn the Device
On/Off
To connect power to the device, please plug the
AC/DC power adapter (shipping along with the
box) into the DC power jack on the side of the
device.
Note: We recommend using a surge protector for
the power connection.
To power on the DSR-150 device, please push
down the power button on the side of the device.
To power off the device, please push down the
power button again, and the power button will
recover the non-pressed position.
D-Link Unified Services Router  3