Transport And Storage - Graf ECO BLOC FLEX Instrucciones Para El Montaje

4.

Transport and storage

4.1 Transport and storage
GRAF EcoBloc Inspect flex system elements are stored and transported in packaging units comprising 14
or 16 modules. The basic measurements of the packaging units are always 0.8 m x 0.9 m (2'-7.4" x 2'-
11.5") GRAF EcoBloc Inspect flex ground plates are usually located on a separate pallet.
The Graf EcoBloc Inspect flex system elements can be transported to the installation location with a fork
lift truck or similar equipment. At the installation location, the EcoBloc Inspect and baseplates can be
moved manually or with light-duty equipment.
A level and stable surface should be used for intermediate storage. Please ensure correct storage. This
means away from negative influences such as fuel, lubricants, chemicals and acids. Storage outdoors
should not be for any longer than one year. The impact sensitivity of the elements also increases as
temperature falls. In particular, impact during frosty weather could damage the elements.
Before installation, the EcoBloc Inspect and ground plates should be checked for damage.
Damaged or defective blocks must not be installed!
4. Transport and storage
20 / 60