Kenmore 122.33492410 Manual De Uso Y Cuidado página 21

9. Side shelf and lid handle assembly
a. Open Grill Head Lid. Loosen but do not remove
the two screws on the outside surface of the Grill
Head. Place the slotted holes on side shelf over the
two screw heads and drop down. Do not tighten
screws until end of next step.
b. Use two 1/4" x 15 mm screws (BB) to attach side
burner shelf to Grill Head from Grill Head inside. Use
these two screws in front and rear holes. Use one
1/4" x 8 mm screw (FF) screw to attach side burner
to Grill head in the center hole. Use one 1/4" x 15
mm screw (BB) and one 1/4" flat washer
(EE) to attach the side burner shelf front
panel to the main control panel. Tighten the
two screws loosened in previous step.
c. From underside of Grill Lid, insert two 1/4 x 15 mm
screws (AA) with 1/4" flat washers (EE), through Lid
and Handle Bezels into Handle ends. Tighten screws
to secure Handle to Lid.
10. Heat Diffusers and Cooking Grates
Place the heat diffusers, main cooking grates and
warming rack into the grill head.
21