Publicidad
Idiomas disponibles
Idiomas disponibles
5 Assembly
Take the table fan out of the package and check the device as well as the scope
of delivery menti oned in the table above. Please contact the vendor if any part is
missing or damaged.
Now place the rear protecti ve cage (5) on the fan unit (1). Make sure that the
handle is facing up. Tighten the protecti ve cage fi rmly using the mounti ng nut (2).
Then insert the rotor blade (3) and fasten it using the appropriate mounti ng nut
(4).
Cauti on: The mounti ng nut needs to be ti ghtened counter-clockwise.
Mount the front protecti ve cage (5) onto the rear protecti ve cage. A hole is provid-
ed for the locking screw (6) at the bott om of the two protecti ve cages.
Insert the locking screw (6) through the hole of the front and rear guards (5) and
fasten it using the locking nut (7).
Then connect the four mounti ng brackets to the side.
Now take the pedestal (8) and assemble it together with the fan unit (1). Finally,
the pedestal (8) is fi xed using the mounti ng screws (9) provided. The table fan is
now ready for use.
6 Usage
Keep the fan in an appropriate locati on and connect the device to a properly in-
stalled 220-240V AC socket.
By ti pping the protecti ve cage, you can now change the angle of inclinati on accord-
ing to your needs.
Push the pin at the top to enable the oscillati on. If you do not want to use the
oscillati on functi on, pull the pin out slightly.
You can select between three diff erent speed levels using the rotary switch on the
pedestal.
English
21
Publicidad
