Publicidad
Idiomas disponibles
Idiomas disponibles
at dusk thereafter. If artificial light sources (such as car headlights) come in
contact with the photo control, it may activate the photo control and turn off the
fixture. If this occurs, the fixture will have to cool down for approximately five
minutes before it will come on again.
I I n n s s t t a a l l l l i i n n g g t t h h e e a a d d j j u u s s t t a a b b l l e e p p h h o o t t o o c c o o n n t t r r o o l l c c o o v v e e r r
The (optional) adjustable photo control cover provides additional flexibility in
allowing you to customize when your light turns on. The twist-lock photo control
is factory preset to turn your light fixture on at a predetermined outdoor light
level. If you would like for your light fixture to come on earlier, follow these sim-
ple instructions for attaching the adjustable photo control cover. First, remove
the cover from the package. The light sensor should already be attached to your
fixture. Position adjustable cover over the photo control (light sensor), and care-
fully press into place (T). You will hear it click over the photo control. You
will notice that there is a lens area on the photo control. Rotate the
cover to where the lens area is positioned in the front of the photo
control. NOTE: You can locate the front of the photo control by the
arrow on the top of the twist-lock photo control. Rotate the cover so
that the heavily dotted area of the lens is in front of the photo con-
trol, which will turn your light fixture on earlier in the evening. To
make the fixture turn on slightly later, rotate the cover towards the lightly dotted
area of the lens.
O O p p e e r r a a t t i i n n g g y y o o u u r r f f i i x x t t u u r r e e
1. Turn on the power at the main fuse/breaker box.
2. Turn power on to the fixture. Your fixture should come on for 1 – 4 minutes,
then go off during daylight installation.
3. To test your fixture, cover the light sensor for 1 – 3 minutes. Your fixture
should come on. Uncover the sensor, and your fixture should turn off in
1 – 4 minutes.
W W h h a a t t t t o o d d o o i i f f . . . . . .
LIGHT DOES NOT
COME ON
OR
LIGHT COMES ON FOR
ONLY A FEW SECONDS
LIGHT STAYS ON
OR
LIGHT CYCLES ON
AND OFF
Is there power to the fixture?
• Has the circuit breaker tripped?
• Is the wall switch ON?
Is the bulb screwed in completely?
• Is the bulb good?
(Be careful not to overtighten)
Is the sensor functioning properly?
• Is light being reflected into the sensor, causing the fixture to
turn off?
• Is the sensor seated properly?
Is the wiring to the unit loose?
TURN OFF POWER BEFORE CONTINUING
• Check connections
• Is the unit properly grounded?
Is the light sensor receiving enough light?
Perform this simple test. Shine a flashlight into the light sen-
sor. NOTE: There is approximately a 2 minute time delay
before the light will turn off. If the light turns off after approxi-
mately 2 minutes, then the light fixture is not getting enough
light. If this is the case, relocate the fixture, or use the
adjustable photo control cover to help shield the light.
5
T
Publicidad
