For You R Safety - Ope Rati Ng You R G Ri Ddle - Char-Broil 19952085 Guía Del Producto

FOR YOU R SAFETY - OPE RATI NG YOU R G RI DDLE

Ignitor Lighting
Do not lean over griddle while lighting.
1. To ignite, push and turn burner control knob slowly (2-3 seconds) to . You should hear
the ignitor click.
2. If ignition does NOT occur in 5 seconds, turn the burner control knob to
minutes and repeat the lighting procedure.
3. If ignitor does not work, follow match lighting instructions.
W A R N I N G
Turn controls OFF and disconnect LP cylinder when not in use.
Match Lighting
1. Insert lit match into the gap between the griddle plate and the firebox, see Fig. A below.
2. Turn the burner control knob to
3. If ignition does NOT occur in 5 seconds, turn the control knob to
and repeat the lighting procedure.
A
Burner Flame Check
Light burner. Make sure burner stays lit while rotating the burner control knob from
Always check flame prior to each use.
setting.
OFF, wait 5 minutes
MATCH LIGHTING
HIGH
LOW
Before Cooking For The First Time
• Remove Proposition 65 Label from Right side of Griddle.
• Leak test your griddle. Operate griddle for 15 minutes with
the griddle controls on HIGH. This will heat-clean internal
components and eliminate odor from paint finish of griddle.
OFF, wait 5
• Season your griddle cooking surface.
Turning Griddle Off
• After cooking, turn the griddle off by rotating the control knob
to OFF. Control knob should pop up in the
If control knob does not pop up, disconnect cylinder to turn
griddle off and replace the Valve/Manifold assembly.
• Allow griddle to cool completely before storing.
S t o r i n g Yo u r G r i d d l e
• Allow griddle to cool completely.
• Remove LP Cylinder and install protective cap over outlet
threads.
• Remove Regulator/Valve from griddle to help keep dirt out of
the propane cylinder probe.
• Store Regulator/Valve in a heavy plastic bag and place inside.
• Be sure the griddle cooking surface is coated with vegetable
oil.
to LOW.
Pa ge 6
OFF position.
C H A R B R O I L. C O M