DeWalt D25901 Manual De Instrucciones página 26

Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING: ALWAYS USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALL USERS AND BYSTANDERS MUST
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... revolutions per minute ....................... speed
BPM ............. beats per minute
IPM ............... impacts per minute
SPM ............. strokes per minute
sfpm ............. surface feet
..................... per minute
.....................
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
n ......................rated
........................speed
.....................earthing
terminal
.....................safety alert
symbol
24
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D WALT tools are factory tested; if this tool does not
E
operate, check power supply.
COMPONENTS (FIG. 1)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. On/off switch
B. Rear handle
C. Electronic impact energy
control dial (D25901 only)
FIG. 1
E
D
D25901
F
E
D
F
D25941
D. Chisel position index collar
E. Tool holder/sleeve
F. Side handle
C
A
B
A
B