Package Information; Periodic Maintenance - Aspes ATE30S Instrucciones De Uso Y Mantenimiento

Temperature setup (for models with adjustable
thermostat) - This setup allows the gradual setting
of the desired temperature, achieved by using a
handle on the control panel.
THE CONTROL LAMP on the panel indicates the
state (the mode) in which the appliance is placed: it
is lit when the water is being heated and is switched
off when the specified by the thermostat water
temperature level is reached.
e
Position (Energy-save mode) – At this mode,
water temperature reaches up to approximately 60
°С. Heat losses are reduced in this way.
Protection according to the temperature (valid
for all models).
The appliance is equipped with a special facility
(thermal circuit-breaker) for protection against over-
heating of the water, which is switching off the heater
from the electricity network, when the temperature
reaches too high values.
Attention! When this device operates, it does not
self-reset and the appliance will not work. Please
call an authorized service for solving the
problem.
VIII. PERIODIC MAINTENANCE
Under normal use of the heater, under the influence
of high temperature, lime scale /the so-called lime
scale layer/ is deposited upon the heating element's
surface. This worsens the heat exchange between
the heating element and water. The heating
element's surface temperature increases along /of
boiling water/. The thermoregulator begins to switch
on and off more frequently. A ''deceptive" activation
of the thermal protection is possible. Due to these
facts, the manufacturer recommends preventive
maintenance of your water heater every two years
by an authorized service center or service base. This
protective maintenance must include cleaning and
inspection of the anode protector (for water heaters
with glass-ceramic coating), which shall be replace
with a new one if need arises. Each preventive
maintenance of the said type must be entered in the
appliance's warranty card and must outline date of
performing the preventive maintenance, company
performing the preventive maintenance, name of
person performing the preventive maintenance, and
signature.
Non-fulfillment of the above requirement may
terminate the free of charge maintenance of your
boiler. In order to clean the appliances use a damp
cloth. Do not clean with abrasive or solvent content
detergents. Do not pour water over the appliance.
The manufacturer does not bare the
responsibility for all consequences caused by
not obeying the instructions, given hereby.
English
DISPOSAL OF PACKAGING AND PRODUCT
Dispose
environmentally-friendly manner.
This appliance is labelled in accordance
with European Directive 2012/19/EU
concerning used electrical and electronic
appliances (waste electrical and electronic
equipment - WEEE). The guideline determines the
frame work for the return and recycling of used
appliances as applicable throughout to the EU.

PACKAGE INFORMATION:

Packaging materials of the product are manufactured
from recyclable materials in accordance with
our National Environment Regulations. Do not
dispose of the packaging materials together with
the domestic or other wastes. Take them to the
packaging material collection points designated by
the local authorities
Instructions for use and maintenancе
of packaging in
EN
an
7