Rainbow SRX Manual Del Propietário página 9

Proper Use and Care
Following a few basic maintenance routines will help provide you with years of trouble-free service from your Rainbow Cleaning System. Neglecting all or part of these
instructions may lead to decreased cleaning efficiency and potentially unnecessary service expenses.
Change the water when dirty...
Do not clean too long with one filling of water. Check water
during cleaning, and if water becomes too thick with lint
and dirt, empty water basin and add fresh, clean water.
For correct water level, fill to top of post in center of
water basin.
Always empty and clean
the basin...
Immediately after using the Rainbow, remove the water
basin and pour out the dirty water through the air intake
opening. Heavier particles will settle to the bottom of the
basin as the water is poured. Once water is poured, remove
the remaining heavier debris and dispose. Then wash the
water basin with soap and water. Rinse and dry thoroughly.
Store the clean, dry water basin on the Rainbow in either
open or closed position.
CAUTION:
!
the water basin when cleaning job is finished. This helps
to avoid odors, growth of germs and bacteria and the
development of water scum in the basin. Hand wash only.
Not dishwasher safe.
Always remove, empty and wash
Clean the separator...
For best performance, remove and clean the separator frequently.
If necessary, use the supplied Rainbow Separator Brush/Wrench to
loosen the nut. Clean the separator inside and out with soap and
water using the Rainbow Separator Brush. Clean and dry the flange
under the separator. Immediately after cleaning, dry and replace
the separator. Hand-tighten the separator nut. Do not force the
separator onto the threaded shaft.
WARNING:
!
Always replace the separator immediately
after cleaning (hand-tighten only). Do not operate the Rainbow
without the separator.
Clearing an obstruction from the hose...
If you notice decreased airflow when using the hose, the hose may
have become clogged. To clear the obstruction, turn off Rainbow
and disconnect from power source. Then, remove the exhaust
vent door on the rear of the Rainbow. Connect the hose coupling to
the exhaust air opening, making sure it is securely locked into place.
Place the hose handle wand into the air intake opening on the front
of the Rainbow. Turn the Rainbow on and jiggle the hose. Any dirt
stuck in the hose will be trapped in the Rainbow water basin.
O W N E R ' S
| 8
M A N U A L