HAMPTON BAY 68144 Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (D) from the canopy (C) by turning
the ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (FF) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (FF) and lock
washers (GG) in the round holes. This will enable you to
remove the mounting bracket (A).
A
C
D
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the two setscrews (RR) on the
collar (TT) on top of the motor housing.
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (TT) on top of the motor housing.
□
Carefully insert the hanger pin (DD) through the holes in
the collar (TT) and downrod (B). Be careful not to jam the
hanger pin (DD) against the wiring inside the downrod (B).
□
Insert the locking pin (EE) through the hole near the end of
the hanger pin (DD) until it snaps into its locked position.
□
Re-tighten the two setscrews (RR) on the collar (TT) on top
of the motor housing.
2
GG
FF
7
Routing the wires
□
Route the wires exiting the top of the fan motor (F)
through the coupler cover (E), and canopy ring (D).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the
ball/downrod assembly (B).
C
D
E
B
F
C
D
E
EE
B
RR
F
Please contact 1-855-HD-HAMPTON for further assistance.
DD
TT
HAMPTONBAY.COM