MTD 19A30003OEM Manual Del Operador página 11

Note: If you decided to leave the hitch support only
finger tight during the assembly process, tighten all of the
hardware securely at this time.
Install the bagger hanger assembly
1. Install the upright support bracket onto the mounting
assembly on the tractor by hooking it over the cross
mounting bracket. See Figure 4-9.
2. Align the upright support bracket with the mounting hole
that best suits the deck size of your machine.
Note: Hole "B" suggested for 42" decks, and Hole "C"
suggested for 46" decks. Some kits may contain plates with
deck size suggestions instead of letters.
Figure 4-9
3. Secure the bag support assembly to the mounting
assembly using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-10.
Figure 4-10
4. Install the hanger assembly onto the upright support
bracket using a carriage bolt (710-0276) and wing knob
(720-04122) from hardware pack 689-00328A. See Figure
4-11.
Figure 4-11
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bagger support rail with
the edge of the snap feature aligned with the red line, as
shown in Figure 4-12.
2. Snap the front side of the chute support to the rail, as
shown in 2 of Figure 4-12.
2
Figure 4-12
S
ection
1
4 — A & i
SSembly nStAllAtion
11