Cree NTW Serie Instrucciones De Instalación

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n'êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3. Suitable for wet locations.
Convient aux emplacements mouilles
4. Suitable for operation in ambient not exceeding 40°C.
Peut etre utilise a une temperature ambiante n'excedant pas 40°C.
5. Suitable for mounting within 1.2M (4ft) of the ground.
Peut etre installe a moins de 1,2 m (4 pi) du sol.
6. Class 1 wiring only.
Cablage de classe 1 uniquement.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1
MOUNTING OVER RECESSED JUNCTION BOX
STEP 1:
Loosen the four screws in the corners of the wallpack housing. See
Figure 1.
STEP 2:
Remove front housing from back box and set front housing aside.
STEP 3:
Remove appropriate knockouts for junction box being used. See Figure 2
for knockouts corresponding to various junction boxes.
1 of 3
IMPORTANT SAFEGUARDS
(4) Screws
Center Grommet
Center Grommet
2
5
4
3
1
STEP 4:
Push supply leads from junction box into the back box through the holes
in the center grommet on the back wall of the back box.
STEP 5:
Attach back box to junction box using hardware supplied by others.
Make sure the back box is positioned so that the stamped brackets with
keyhole slots are located at the top of the box. The bubble level on the
back box should be used to make sure the back box is properly leveled.
See Figure 3.
NOTE: To ensure a watertight seal, a high grade caulking material, such
as silicone rubber, should be used between the back gasket and the
mounting surface.
NTW Series
LED Wall Pack
NTW Small Wall Pack
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
7
2
LPN00628X0001A0_A
6, 7
1, 2, 3
4, 5
6