Powis Parker Hardcover Guide Manual Del Usuario página 4

FASTBACK HARDCOVER GUIDE USER'S MANUAL, REV.:C 06/09/05
CREATING A HARDCOVER BOOK
(cont.)
Slide the Instruction Card to the upper right
corner of the base (Fig. 5). The white tab fits
under the clamp and the front left angle fits
behind the base notch. For thicker covers,
this card should be removed.
5
F I G U R E
Place your Fastback Hardcover™ on the Guide
with the release papers facing up, (the back
cover of the book should be to the right).
Slide the cover to the right rear corner of the
base (Fig.6–Step 1). The right and top edges of
the cover should contact the right and rear steps
of the base, with the cover under the paper
stops (step 1 arrows). Flip the lever to the right
to clamp the cover in place (step 2 arrows).
6
F I G U R E
Remove the strip of narrow release paper to the
right of the spine (Fig. 7).
7
F I G U R E
With the front of your book block facing up,
push the page edges against the top and side
green paper stops (and spacers if required —
see page 3, Fig. 4). With the page edges held
against the edges of the paper stops and spacers,
push the spine edge of the book block down
firmly onto the exposed narrow adhesive strip
(Fig. 8).
8
F I G U R E
4