FASTBACK HARDCOVER GUIDE USER'S MANUAL, REV.:C 06/09/05
CREATING A HARDCOVER BOOK
(cont.)
With the spine edge attached, carefully rotate
the book block to the left. Remove the wide
release paper on the right side (Fig. 9). Roll the
book block back to the right onto the exposed
adhesive, securing the back endleaf.
9
F I G U R E
Remove both the narrow and wide release
papers on the left hand side of the cover (Fig. 10).
10
F I G U R E
Lift the front cover over the top of the book
block (Fig. 11). The cover edges must contact the
rear and side purple cover stops (Fig. 11 detail
arrow). Then press the cover down onto the
book block.
11
F I G U R E
Flip the lever up to release your book.
Open front and back covers to smooth down the
inside endleaves (Fig. 12).
Your Fastback® Hardcover™ book is done!
12
F I G U R E
5