G - Using The Product With A Thomson Network Video Recorder; H - Using The Product With A Thombox; Pairing Mode - THOMSON DSC-523W Manual De Instrucciones

g - uSiNg ThE prOduCT WiTh A ThOMSON NETWOrK VidEO rECOrdEr

Your camera is compatible with the ONVIF protocol
and can be paired with a network video recorder.
• Connect your camera to the network or one
of the recorder network sockets and run a
camera search on the recorder.
Your network recorder needs the following
information:
• The IP address of your camera: if the recorder
cannot find the camera automatically, provide
it with the IP address discovered by the 'IP
Camera Search Tool' supplied on the CD (see
paragraph D - 1 - ACCESS TO CAMERA
CONFIGURATION)
• Your camera's ONVIF port: if the recorder does
not discover this automatically, the default port
number is 888.
• A username and password: these are the same
usernames and passwords you use to connect
to your camera (default username = admin;
default password = none)
• When you have entered all the information into
the recorder, add the camera in the same way

h - uSiNg ThE prOduCT WiTh A ThOMBOX

1 - PAIRING MODE

Your camera is optimised for use with a Thombox.
First of all your camera must be set up and
connected to the same computer network as the
Thombox.
• Go to the interface of your Thombox to pair
your camera, « General » tab
• To pair your camera click on
STEP 1: click on the «IP CAMERA» network
14
en
Motorised 720P Hd WiFi iP caMera
as you would with the original cameras. After
a few seconds, your camera feed will appear
beside the feeds from your original cameras.
You will then be able to record videos onto the
recorder's hard disk and use the recorder's
motion detection, just like with the original
cameras. You can also control your camera's
motors and continue to use your IP camera as
before with your smartphone or computer.
STEP 2: Your Thombox will then check for other
compatible cameras on the computer network. Wait
while this process is being carried out.