Troubleshooting - Insignia IS-PDVD10 Guia Del Usuario

10-2 inch swivel screen DVD.book Page 46 Tuesday, June 21, 2005 7:37 AM

Troubleshooting

If you experience the following problems while using the player, this
troubleshooting guide can help you.
No sound
• Make sure that the player is connected securely.
• Make sure that the volume of the headphone is set to MIN
when using a headphone.
• Make sure you operate the TV or amplifier correctly.
• Make sure you have selected DVD player position on the
amplifier.
No image
• Make sure that the player is connected securely.
• Make sure that you operate the TV correctly.
• Make sure that you set the color system correctly.
Bad sound quality
• Make sure that the audio output mode is set correctly.
• Make sure that the audio connection between the player and
amplifier is correct.
Disc cannot be played
• Make sure that there is a disc in the player.
• Make sure that the disc is placed on the disc tray properly, with
the label side up.
• Make sure the disc is clean.
• If moisture has condensed in the player, remove the disc and
leave the player on for about one hour.
Remote control does not work
• Remove barriers between the remote control and the player.
• Point the remote control at the remote control sensor of the
player.
• Replace the batteries with new ones.
Image rolls and has no color
• The color system of the player doesn't match with that of TV.
Select the correct TV TYPE until TV shows normal color.
No power
• If connected to an AC adapter:
•
•
•
• If connected to a battery:
46
IS-PDVD10 monitor portable DVD player
Make sure that the plug is correctly inserted in the wall
socket.
Make sure that the AC adapter is inserted to the correct
plug on the DVD player.
Make sure that the wall socket has power (Some wall
sockets are controlled by a switch).
www.insignia-products.com