Troubleshooting And Replacement Parts; Troubleshooting Chart - Wayne WIP Serie Manual De Instrucciones De Funcionamiento Y Piezas De Repuesto

Troubleshooting and Replacement Parts

Troubleshooting Chart

Symptoms Possible Cause(s)
Motor does not start 1. Disconnect switch or circuit breaker in OFF position
2. Fuses blown or thermal overload open
3. Disconnected or defective wiring
Motor does not reach full 1. Low voltage
speed
2. Motor windings connected for wrong voltage
Motor overheats 1. Low voltage
(protector trips)
2. Motor windings connected for wrong voltage
3. Inadequate ventilation
Pump does not deliver 1. Pump is not primed
water
2. Suction or discharge valve is closed
3. Leakage or air into suction system
4. Hair and lint strainer is full
5. Water level in swimming pool is too low
Noisy pump and motor 1. Plugged basket in skimmer or hair in lint strainer
2. Valve in suction line partly closed
3. Vacuum hose plugged or too small
4. Pump not supported properly
Low pump capacity 1. Valve in suction or discharge line partly closed
2. Suction or discharge line too small
3. Plugged basket in skimmer or hair in lint strainer
4. Dirty filter
Leakage of water at shaft 1. Shaft seal requires replacement
High pump pressure 1. Discharge valve closed
2. Return lines too small
3. Dirty filter
Air bubbles collecting in 1. Leakage of air into suction line at connections or valve
strainer
2. Strainer cover leaking
3. Restriction in suction line
4. Low water level in swimming pool
For Replacement Parts or
Technical Assistance, call
1-800-237-0987
Please provide following information:
- Model number
- Serial number (if any)
- Part description and number as shown in parts list
Address parts correspondence to:
WAYNE Water Systems
101 Production Drive
Harrison, OH 45030 U.S.A.
Ref. No. Description
1 Strainer Cover and Gasket
2 Strainer
www.waynepumps.com
stem
Order No.
69010-001
28477-001
Electrocution hazard! Pump can start automatically. Disconnect
the power before attempting any repairs. Failure to follow these
instructions WILL result in serious injury or death.
Corrective Action
1. Reset breaker
2. Check voltage
3. Check wiring
1. Check voltage settings
2. Inspect motor voltage selector
1. Check voltage settings
2. Inspect motor voltage selector
3. Remove obstructions around pump
1. Prime pump as directed in the "Operation" section
2. Open the valve
3. Eliminate leaks in suction line
4. Clean strainer (see maintenance section)
5. Fill swimming pool to proper level
1. Clean skimmer and lint strainer
2. Open all valves during operation
3. Check for collapsed hose and replace
4. Add additional supports
1. Open all valves
2. Use larger supply line
3. Clean skimmer and lint strainer
4. Clean filter (see filter manual)
1. Replace seal
1. Always run with valves open
2. Replace with larger lines
3. Clean filter (see filter manual)
1. Eliminate leaks in suction line
2. Remove and clean o-ring
3. Increase suction line size
4. Fill swimming pool to correct level
Quantity
1
1
6
1
2