Velleman VM101 Manual Del Usuario página 9

O O
Function 12
O
Function 13
LD1 will flash at an interval a number of times if the module detects an irregularity during the self-test.
Remove all connections and re-establish them if the module malfunctions. Send the module to your dealer for
repairs if it still doesn't work properly.
(*)Function 14 :Learning Mode (
Certain modes use delays stored in DELAY1 and DELAY2. The learning mode allows you to store two different delays,
DELAY1 and DELAY2, each from 5s up to 2h. Default values are DELAY1 : 3 minutes and DELAY2 : 1 minute. You can
change these delays to suit your needs. The delays are stored in EEPROM and will not be erased in case a power failure.
Max. intensity as long as the button is pushed. Release to turn off.
Momentary mode
Application: external control by e.g. timer
Push repeatedly to select OFF, 40%°, 60%°, 75%° and 100% of nominal speed .
Speed control for
To ensure startup of the motor full power is applied for 2s after first push. Actual
synchronous
speed depends on applied motor.
(brushless)motors.
Application: Speed control of a brushless fan. (e.g. Ventilator)
O)
Learning Mode & Factory settings
9