Buffalo WHR-HP-G54 Guia De Inicio Rapido página 10

EN
Additional Information
AOSS (AirStation One-Touch Secure System)
The WHR-HP-G54 supports Buffalo's AOSS system for connecting AOSS
compatible wireless clients to the WHR-HP-G54. For information about AOSS,
please refer to the AOSS Supplement which is included in the WHR-HP-G54
package contents.
IP Addressing
To verify your IP settings for static or automatic addressing, click Start, select
Settings (if present) and click Control Panel. Within Control Panel, double-click
Network or Network Connections. You can then right-click on any of your
wired or wireless connections and select Properties. Within the properties,
you can view the properties of your TCP/IP protocol.
Generally, you will want to be sure that Obtain an IP address automatically
is selected to allow easier connections. To manually renew IP addressing
configurations for your connection, follow these steps:
• Click Start and Run. A dialog box will appear where you can type cmd into
the field provided and click OK.
• An MS-DOS prompt will launch. Enter IPCONFIG /RELEASE and press the Enter
key on the keyboard to release your current IP configuration. Next, enter
IPCONFIG /RENEW and press the Enter key to seek new settings from a DHCP
server. (This may take a few moments).
• Type IPCONFIG /ALL. This will display all the IP configurations for your wired
or wireless connection.
• The Default Gateway address listed in the results is usually the IP address
of the AirStation. If no IP addresses are listed or your wireless adapter
displays a 169.254.XXX.XXX address, retrace the setup steps to verify correct
installation.
• Type EXIT to close out the DOS window.
Warning : Please note it is not permitted under EU Legislation to use external
antennas with the WHR-HP-G54.