Buffalo WHR-HP-G54 Guia De Inicio Rapido página 5

Connecting Cables To The AirStation
Ethernet cable to PC
AC power
Fig: 2
1. Power down the Cable or DSL modem and the computer which will be
used to configure the AirStation router.
2. Screw external antenna on to top of AirStation.
3. Plug the Cable or DSL's LAN Ethernet cable into the AirStation's WAN port.
Initially, you may need to unplug this cable from your computer, hub or other
router.
4. Plug the provided Ethernet cable into a LAN port on the AirStation and
plug the other end into your computer's Ethernet adapter's (NIC) port. If you
plan to initially configure the AirStation wirelessly (not recommended), you
may skip this step.
5. Power on your cable or DSL modem and wait one full minute, then power
on the AirStation router (by plugging in its power) and wait another minute,
and finally power on the computer which will be used to configure the
AirStation. If the red DIAG light on the AirStation is lit or flashing after several
minutes of being powered on, please consult Buffalo Technology Technical
Support.
Ethernet cable to
Cable/DSL modem

EN
2