Publicidad
Idiomas disponibles
Idiomas disponibles
Before using your new Steren´s product, please read this instruction
manual to prevent any damage.
I M P O R T A N T
The instructions of this manual are for reference about the product. There may
be differences due to updates.
Please check our web site (www.steren.com) to obtain the latest version of the
instruction manual.
C A U T I O N S
• Do not expose the equipment to extreme weather.
• Do not use or store the equipment near wet places. May cause malfunction or shock
hazard.
• Clean only with a soft, dry cloth.
• Do not use this equipment if the power cord is broken or damaged.
• Do no try to open the equipment, may cause malfunction and warranty repeal.
H I G H L I G H T S
Your new amplifier has one microphone inputs, one auxiliary input and independent
volume controls for each device. It counts with a short circuit protector, offering you
more security.
C O N T R O L S
H O W T O U S E
1. Connect DC cables to a 12V- - - power source (red positive, black negative).
2. Connect speaker cables (blue positive, grey negative).
3. Make sure that the main switch is in the off position and plug the connector to
amplifier.
4. Set all controls at minimum.
5. Turn on amplifier.
6. Adjust volume knobs according to your needs
SIREN
S
7. You can activate siren for short periods of time (press switch to
the left) or for long periods (press switch to the right).
A
PUSH ON
8. Select siren's tone using selector.
O U T P U T C O N N E C T I O N S
Output to low impedance speakers:
This terminal has been made for low impedance speaker (4, 8 and 16 ohm) and
connections with few speakers. Use this terminal with a cable not larger than 164ft.
For a better current distribution, the amplifier requires that the total charge be the
same as the amplifier's output impedance (4, 8 and 16 ohm).
Make sure that the total impedance
from the connected speakers are higher
than 4ohm (4, 8 or 16 ohm).
Do not raise the volume level higher
than the permitted by the speaker's
input. Otherwise you can cause several
damages on the speakers.
Connection Examples:
If you have:
Two speakers of 8 ohms, if you connect in parallel, the
output impedance will be 4 ohms.
Two speakers of 8ohms, if you connect in serial,
the output impedance will be 16 ohms.
S P E C I F I C A T I O N S
Type: Car amplifier
Output proportion: 15Wrms @ 4 ohms
Connectors: 1 microphone– 50dB, Auxiliary -22dB
Frequency response: 50Hz – 15kHz
THD: less than 1% @ 1kHz
Alarm: Constant
Siren: Automatic wave type, electronically operated
Input: 12V- - -
Input impedance: Microphone 200 – 50kohms, auxiliary -22dB
Input level: Microphone 50 – 1dB, Auxiliary -22dB
Power consumption: 45W maximum output
Output impedance: 4 – 16 ohms
Nominal consumption: 360 Wh/day
Stand-by power consumption: not applicable
Product design and specifications are subject to change without notice.
Product: 15W Car amplifier
Part number: AMP-015
Brand: Steren
This Steren product is warranted under normal usage against defects in workmanship and materials to the original purchaser for one year from
the date of purchase.
1.- This warranty card with all the required information, invoice or purchase ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim was received.
4.- Steren sell parts, components, consumables and accessories to customer, as well as warranty service, at any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky batteries, failure to follow enclosed instructions, improper repair by
unauthorized personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or purchase ticket.
RETAILER INFORMATION
Name of the retailer ____________________________________
Address _____________________________________________
Product ______________________________________________
Brand _______________________________________________
Serial number _________________________________________
Date of delivery _______________________________________
In case your product fails or have questions, please contact your nearest dealer. If you are in Mexico, please give a call to our Call Center.
Two speakers of 8ohms, if you connect in
serial/parallel, the output impedance will be
8 ohms.
WARRANTY
CONDITIONS
01 800 500 9000
Publicidad
