Deviation To The Rule; Modification Of Given Times - Dreve Drufomat scan Instrucciones De Trabajo

Drufomat scan

9. Deviation to the rule

9.1 Modification of given times

Scanned times may be prolonged or
shortened individually, if required.
Info
The performance of the heating
might decrease slightly after 1000
operating hours. By prolonging
the heating times by 5-10 seconds
optimum thermoforming results
can be attained again. The times
given by the barcodes are aver-
age times and designed for gen-
eral use. In case of extreme under-
cut areas or very high models a
prolongation of the heating time
can optimise the results.
After having scanned the pre-adjusted
material parameters (see paragraph
8.1) the heating time (1 x) or the cool-
ing time (2 x) can be selected by press-
ing the menu key (j). There will be an
arrow in the display in front of the cho-
sen time. The heating time can be modi-
fied positively and negatively in steps of
5 seconds. For this press the menu keys
(e/i) according to the key description.
The max. deviation from the scanned
time is 35 seconds.
40
With the same working steps the cool-
ing time can be modified in steps of
10 seconds by max. 70 seconds.
For identification of the modified para-
Meters the display will show a + resp.
a - sign. The degree of deviation will be
shown by a scale at the bottom of the
display. Modified values have to be con-
firmed by pressing the OK key (f).
All further working steps correspond
to 8.2.