Fabrication Of Cast Form Parts - Dreve Drufomat scan Instrucciones De Trabajo

Drufomat scan

10.3 Fabrication of cast form parts

With the K-7 insert it is possible to
thermoform up to 7 resin bases for
the crown and bridge technique at the
same time.
Fix the single dies by means of a flexible
blocking out material (e. g. Fillin) in the
holes of the K-7 insert.
Remove the nub plate from the F insert
(6) and replace it by the K-7 insert.
All further working steps as described
from point 8.1 on.
46