Hubbell System-One Instrucciones De Instalación página 4

ABANDONMENT PLUG INSTALLATION INSTRUCTIONS
(Purchased separately):
S1FRP4xx Fire Rated Closure Plugs provide a method of
abandoning the Hubbell S1R4PTxx series fire rated poke
through. This product will maintain the fire rating of the poke
through installation.
1. Disconnect power and/or telephone/data of the poke through.
2. Remove cover assembly by removing screws (h) attaching
cover to the can. See Fig. 2.
3. Service fitting may be removed by driving unit through to the
lower floor.
4. Install S1FRP4xx per included instructions.
PRE-POUR TUBE (PPT) INSTRUCTIONS (Purchased separately):
Slide (2) tube segments (aa) together using dovetail joints.
Segments are identical except for location of holes (ab).
Assemble brackets (ad) as required as shown in figures 7 and 8.
Brackets are marked to assist assembly. Turn hexagonal head
screws (ac) horizontally to support the disc (at). Insert discs (at)
at top, center and bottom. Bend brackets (af) for center and
bottom positions to fit inside the assembled tube segments.
STEEL DECK INSTALLATION
1. Cut hole 4.06" to 4.12" in diameter into deck.
2. Install assembly into cut hole, see Fig.7. Check that the
assembly is installed plumb to the deck. Attach to deck with
sheet metal screws (not supplied).
3. Adjust the height of the assembly so that the top of the cap
protrudes above the maximum thickness of the desired
concrete pour.
4. Seal perimeter of PPT with tape.
PLYWOOD DECK INSTALLATION
1. Attach assembly to the deck with appropriate fasteners (not
provided). See Fig. 8.
2. Seal deck area around PPT with tape.
AFTER ASSEMBLY – Pour concrete and let cure. AFTER
CURE - Remove discs (at) and hexagon head screws (ae).
Drive one of the segments (aa) downward until released from
the concrete. Brackets (ad) will remain inside the resulting hole.
PD2552
(Page 2) 02/14
Fig. 6
(aa)
(ab)
Fig. 8
PRINTED IN U.S.A.
(at)
(ae)
(ad)
(af )
(at)
(af )
Fig. 7