Troubleshooting; Cleaning And Care; Cleaning The Filter; Storage - FLORABEST HG00549 Instrucciones De Utilización Y De Seguridad

Ocultar thumbs Ver también para HG00549:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
Note: If the
display
not possible. Irrigation which may be occurring will
be interrupted.
Programming will be saved for 2 minutes. If chan-
ging the batteries takes longer, all settings must be
selected again.

Troubleshooting

This product contains delicate electronic components.
For this reason, it may be disrupted by transmissions
from transmitters in the direct vicinity.
Note: Electrostatic discharge can cause malfunc-
tions. If this happens, briefly remove the batteries
from the battery compartment
again after 10 minutes. The product will be fully re-
set. The product will then be ready for use again.
Note: Please note that all settings will be deleted if
the product is reset.
Error
Possible
Cause
No notifica-
No batteries
tions on the
inserted
display
The batteries
are dead
Irrigation will
The tap is
not start
closed
Wrong pro-
gramming
No batteries
or dead
batteries
22 GB/IE
flashes, irrigation is
16
and reinsert them
10
Solution
Insert batteries
Replace the
batteries
Open the tap
Check the
programming
Insert batteries
or replace the
batteries

Cleaning and Care

Attention! Potential damage to the product.
Moisture entering the product may result in damage.
Ensure no moisture enters the battery compartment
during cleaning to prevent damaging the product
10
beyond repair.
Only clean the housing with a slightly damp
cloth and mild washing-up liquid.
Never use petrol, alcohol or other aggressive
cleaning agents to clean the housing.

Cleaning the filter

The filter
must be regularly checked and
11
cleaned if necessary.
Close the tap.
Allow the product to run dry by manual irrigation.
Unscrew the union nut
adapter thread.
Remove the conical filter from the water inlet
in the union nut.
Clean the filter.
Reinsert the filter.
Screw the union nut onto the thread of the tap
or adapter.
Open the tap.

Storage

Close the tap.
Loosen the hose from the coupling
Allow the product to run dry.
Loosen the union nut
Remove the batteries.
Store the product in a dry and frost-free environ-
ment.
from the tap or
1
.
13
.
1

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido