Radio Installation; Mounting The U-Bracket; Control Head Handling Precautions; Installing The Control Head On The Radio Body - Tait Electronics TM8100 Guia Del Usuario

Mounting the U-bracket

Screw the U-bracket in the chosen mounting position using
the self-tapping screws provided. At least four screws must
be installed. If the U-bracket is being mounted over a curved
surface, bend the U-bracket tabs slightly.

Control head handling precautions

remove the control head in a static-safe environment.
Information on antistatic precautions can be found at the
Electrostatic Discharge Association (ESD) website,
www.esda.org.

Installing the control head on the radio body

The orientation of the U-bracket mounting determines which
way up the control head is mounted on the radio body. The

26 Radio installation

Radio installation
Important: Check that the U-bracket is not distorted
when the screws are tightened.
Important: The control head contains devices which can
be damaged by static discharges. Always install or
2
1
2