Oxygen audio PULSION 12.1 Manual Del Usuario página 34

No Sound
In AUX-IN
mode, short
interruption
occurs from
time to time
No response
from the unit
Remote
control does
not work
FM station
cannot be
stored
Speaker
makes loud
noise
Unit powers
off after 60
minutes
The battery is
not charging
 When playing from the AUX input, Make sure the external
source has the volume turned up and is playing a track.
 Make sure the volume is turned up.
 When playing in AUX-IN mode, Make sure the other
device's connection is Output not Input.
 Make sure to connect to AUX-IN port and not AUX-OUT.
 Bluetooth device not paired. Refer to "8. Bluetooth
operation".
 USB/SD can only support the MP3 file format. Other
formats could not be read.
 Under a very large volume, speaker may enter
autoprotection mode and mute for a short while. Please
reduce slightly the volume in order to avoid this situation.
 Unplug the power cable for 1 minute then plug back in
again.
 Check the batteries are installed correctly.
 Replace the batteries.
 Aim the remote directly at the speaker.
 The radio channels which are searched manually could
not be saved
 Keep the microphone 2 meters away from the speaker.
 Turn off microphone if not in use.
 Adjust microphone volume to lower mode.
 Keep mobile away from the speaker when attending a
call.
 Keep the speaker away from other wireless equipment.
 If AUX cable is plugged to one end only and not plugged
to another device, it may cause buzz noise. In this case,
please unplug the cable.
 This unit is
automatically after 60 MINUTES of inactivity. Press the
STANDBY or POWER button to wake the unit.
 Battery will be charging in On and Off modes. In
accordance with low power consumption directives, the
battery will not charge in standby mode.
designed to enter STANDBY mode
- 33 -