Ce Conformity Declaration; Disposal Notes - Multiplex RX-6-DR light M-LINK Manual De Instrucciones

HFM3 M-LINK / HFM4 M-LINK / HFMx M-LINK 2.4 GHz RF
module).
2. The range of the RX-6/7-DR light M-LINK receiver must be at
least fifty metres with the transmitter set to low power. You have
reached the range limit when the servos start to move jerkily.
There must be visual contact between the transmitter and
receiver aerials (i.e. the model) during the range check.
Keep the transmitter and the model about one metre above
ground during the range check.
3. If your transmitter features an automatic servo test facility,
we recommend that you activate it for one control function
(e.g. rudder). This sets up a steady movement of the servo,
and enables you to detect the limit of range clearly.
Important:
Carry out the first range check with the motor switched off.
Turn the model into all attitudes, and attempt to optimise
reception by changing the position of the two aerials.
For the second range check, run the motor at varying speeds
and check that the effective range is not significantly reduced.
If there is a marked reduction, locate and eliminate the cause
of the interference (caused by the motor, the arrangement of
the receiving system and power supply, vibration, etc.).
11. CE C
ONFORMITY
This device has been assessed and approved in
accordance with European harmonised directives.
This means that you possess a product whose design and
construction fulfil the protective aims of the European Com-
munity designed to ensure the safe operation of equipment.
The detailed CE conformity declaration can be downloaded in
the form of a PDF file from the Internet under www.multiplex-
rc.de. It is located in the DOWNLOADS area under PRODUKT-
INFOS.
12. D N
ISPOSAL OTES
Electrical equipment marked with the cancelled waste
bin symbol must not be discarded in the standard
household waste; instead it should be taken to a
suitable specialist disposal system.
In the countries of the EU (European Union) electrical equipment
must not be discarded via the normal domestic refuse system
(WEEE - Waste of Electrical and Electronic Equipment, Directive
2002/96/EG). You can take unwanted equipment to your nearest
local authority waste collection point or recycling centre. There
the equipment will be disposed of correctly and at no cost to
you.
By returning your unwanted equipment you can make an
important contribution to the protection of the environment!
13. G / L
UARANTEE
The company MULTIPLEX Modellsport GmbH & Co.KG accepts
no liability of any kind for loss, damage or costs which are due to
the incorrect use and operation of this product, or which are
connected with such operation in any way. Unless the law
expressly states otherwise, the liability on the part of MULTI-
PLEX Modellsport GmbH & Co.KG to pay damages, regardless
of the legal argument employed, is limited to the invoice value of
those products supplied by MULTIPLEX Modellsport GmbH &
Co.KG which were directly involved in the event in which the
damage occurred. This does not apply if liability is incurred
according to statutory law on account of intentional or gross
negligence.
Operating Instructions RX-6-DR light M-LINK /
RX-7-DR light M-LINK 2.4 GHz receiver
D
ECLARATION
E
IABILITY XCLUSION
We guarantee our products in accordance with the currently
valid statutory regulations. If you wish to make a claim under
guarantee, your initial course of action should always be to
contact the dealer from whom you purchased the equipment.
The guarantee does not cover faults and malfunctions which are
caused by the following:
•
Incorrect or incompetent use
•
Maintenance carried out incorrectly, belatedly or not at all, or
not carried out by an authorised Service Centre
•
Incorrect connections
•
The use of accessories other than genuine MULTIPLEX
items
•
Modifications or repairs which were not carried out by
MULTIPLEX or by an authorised MULTIPLEX Service
Centre
•
Accidental or intentional damage
•
Defects due to normal wear and tear
• Operation of the unit outside the limits stated in the
Specification
•
Operation of the unit in conjunction with equipment made by
other manufacturers.
14. R
ECOMMENDED
A
B
C
Page 10
I
NSTALLATIONS