Troubleshooting; Replacement Parts - Omega 22201 Manual De Piezas E Instrucciones De Funcionamiento

Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that wheels,
casters and pump assemblies move freely. To help ensure trouble free operation, an inline air dryer and oiler is recommended.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily cloth.
Note: Never use sandpaper or abrasive material on these surfaces!
Storage
When not in use, store the jack with saddle fully lowered.

TROUBLESHOOTING

Symptom
Jack will not lift load
Jack will lift, but not maintain
pressure
Jack will not lower after unloading
Poor lift performance
Will not lift to full extension

REPLACEMENT PARTS

(refer to page 6 thru 9)
Not all components of the jack are replacement items, but are illustrated as a convenient reference of location and position
in the assembly sequence. When ordering parts, give Model number, serial number and parts description. Call or write for
current pricing: SFA Companies, 10939 N. Pomona Ave. Kansas City, MO 64153, U.S.A.
Tel:(888)332-6419 Fax:(816)891-6599 E-Mail: sales@omegalift.com Omega Website: http://www.omegalift.com
Possible Causes
• Release valve not tightly closed
• Overload condition
• Air pressure inadequate
• Release valve not tightly closed
• Hydraulic unit malfunction
• Reservoir overfilled
• Linkages binding
• Fluid level low
• Fluid level low
• Air trapped in system
• Fluid level low
5
Corrective Action
• Ensure release valve tightly closed
• Remedy overload condition
• Ensure adequate air pressure
• Ensure release valve tightly closed
• Discontinue use, contact Omega
technical service
• Drain fluid to proper level
• Clean and lubricate moving parts
• Ensure proper fluid level
• Ensure proper fluid level
• See Page 3 for bleeding/Venting
Trapped Air
• Ensure proper fluid level