Battipav Prime 500 Manual De Instrucciones página 32

GB
Danger of accidental contact with the moving tool.
OPERATORS MUST WEAR HEAVY PROTECTIVE GLOVES
Danger of exposure to fragments of materials.
OPERATORS MUST WEAR PROTECTIVE GOGGLES.
ALWAYS STAY IN THE WORKING POSITION (Pos. 1 picture 16) DURING THE MACHINE OPERATION PHASES:
• During material loading;
• During material cutting;
• During the cutting tool deceleration following the machine stop.
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
MOTOR CARRIAGE ADJUSTMENT
The motor carriage is provided with two registers for the motor head vertical play adjustment.
For correct adjustment, proceed as follows:
25
• with a 3 mm Allen wrench, screw both front adjustment dowels (A), until the play is eliminated.
26
• repeat the operation for both back adjustment dowels (B).
TIGHTEN THE FOUR REGISTERS EQUALLY IN ORDER TO OBTAIN SUITABLE SMOOTHNESS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
27
It is extremely easy to clean the PRIME machine by loosening the locking nuts and dismantling the working table.
Through the tap located on the bottom of the recovery tank, remove any working residual from the machine.
FOR THE CORRECT POSITIONING OF THE REGISTERS, USE A SQUARE SHOWING THE 45°.
28
AFTER THE TANK CLEANING OPERATIONS, PLACE THE WORKING TABLE BACK IN POSITION, OBSERVING THE DISTANCE
FROM THE LEG SUPPORT. (90500/90501=212 mm, 90650/90651/ 90700/90701=315mm )
29 30
Clean the sprayer regularly as indicated.
DISPOSAL
In the event of scrapping the entire machine, it must be disposed of in accordance with the methods laid down by current legislation.
Main Casing
Submerged Pump
Electric Motor
R.A.E.E. IT08020000002803
The European Directive 2012/19/EU arranges that in the event of scrapping of electrical equipment, they must not be
disposed of city solid refusals but collected separately, in order to optimize the level of recovery and recycling of the
materials and above all in order to prevent damages to health and environment. To comply with European Directive
2012/19/EU, all electrical equipments must be marked with crossed basket symbol. The packing of the machine will be
disposed of in accordance with the methods laid down by current legislation. For further information concerning disposal of
electrical equipment, please refer to public administration service.
32
Polyamide Steel Alluminio Copper
Battipav srl
Epoxy Resin