Klarstein Basel Manual De Instrucciones página 22

EN
22
Figure 3: Mark the lower fixing bracket
two fixing hole positions on the wall-see
Fig.3, remove the heater. Drill the wall
and insert the wall plugs. Refit the heater
to the wall and fasten the bottom fixing
bracket to the wall using the screws
provided to permanently fix the heater
in place.
Mounting the Fireplace Stand
It is possible to install the electric fireplace on a surface, instead mounting it on the wall.
• Remove the tempered glass from the metal body.
• Place the metal body horizontally on a table.
• In the lower part of the body there are some holes; align them to the holes on the
fireplace stand.
• Use the supplied screws to secure the base to the lower side of the main body.
• Place the unit on a flat and stable surface.
• With some help, install the tempered glass.
• Align the lateral hooks of the glass with the notches on the sides of the metal body.
Figure 4: Place the front surround over
the front of the fire aligning the slots in the
brackets at each side of the front panel
with the lugs on the sides of the fire-see
Fig.4. Again two people will be required
for this operation.