Beamz Pro CC1200 CONFETTI Manual De Instrucciones página 5

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and have been
received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from shipping or the
package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to the factory, it
is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this,
all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be
used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to avoid the
risk of electrocution or fire.
Step 1: Place the unit on a flat surface and in a suitably large area with at least 50 cm of open space around the
unit.
Step 2: Do not orientate the escape nozzle directly in the direction of the audience's eyes.
Step 3:To adjust the output angle, release the fixation screw, adjust the desired angle and retighten the fixation
screw.
Step 4: Connect the DMX via 3pin XLR cable and plug the mains plug into a wall socket.
Step 5: Turn on the unit, put the power switch to the "ON" position. The LCD display will show "WARMING UP".
After few seconds the LCD display will shows "READY".
Step 6: Adjust the settings via LCD display.
Step 7: Fill the unit with loose confetti (accessory).
When display shows "READY", you can start producing haze and adjust the settings via LCD display panel.
Menu Description
Man Vol Out xxx% Adjust the manual volume output within the range of 0% to 100% by means
of the Up/Down keys.
Interval Set xxxS Adjust the interval between 1 to 100S by means of the Up-/Down keys.
Duration Set xxxS Adjust the duration between 1 to 100S by means of the Up-/Down keys..
Volume Out xxx% Adjust the volume output within the range of 0- 100% by means of the Up-
/Down keys.
DMX 512 #xxx Adjust the DMX address for DMX control by means of the Up-/Down keys.
Wind For Class xx Adjust the wind output during the function within the range of 0- 100% by
means of the Up-/Down keys.
Angel Set xx% No function for this model.
Wireless Turn on/off wireless remote.
W IRELESS REMOTE
A: ON / OFF
B: ON / OFF
C: Output volume up
D: Output volume down