Starting A Wash Cycle; Changing The Programme During The Wash Cycle - Blaupunkt 5VF4X00EME Instrucciones De Uso

STARTING A WASH CYCLE

1. Pull out the lower and upper basket, load the dishes and push back the baskets. We
recommend loading the lower basket first, then the upper basket.
2. Add detergent.
3. Plug the power plug into the socket. Power supply: see last page of the product data sheet.
Make sure that the water supply is switched on completely.
4. Open the door and press the power button.
5. Select a programme, the answer lamp will light up. Then close the door. The dishwasher will
now start the wash cycle.
CHANGING THE PROGRAMME DURING THE WASH
CYCLE
You can only change a wash cycle can if it has only been running for a short time. Otherwise, the
detergent may have already been released and the dishwasher may have already drained the rinse
water. If this is the case, the dishwasher must be reset and the detergent dispenser refilled. Follow
these instructions to reset the dishwasher:
1. Open the door slightly to stop the dishwasher. When the movement of the spray arm has
stopped, you can open the door fully.
2. Press the programme button for more than three seconds to put the appliance in standby
mode.
3. You can now change the programme.
3 seconds
26