Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

6703, 6704
Operation & Maintenance Manual
Model Numbers
6703
Identity Hand Shower System
6704
Identity Tub/Hand Shower System
Modifications
CG
-1.5
1.5 gpm (5.7 L/min) flow restrictor
-2.0
2.0 gpm (7.6 L/min) flow restrictor
6' metal hose in place of 5' standard
-72
metal hose
30" slide bar in place of wall cradle
-B30
48" slide bar in place of wall cradle
-B48
-CHKS
Integral check stops - for use in
installations where a positive shut-off
device is used downstream of mixing valve
-IPS
1/2" female IPS connections
Less hand shower
-L/HS
-LP
Loop handle
-LR
Lever handle
-OP
13" oval plate
Quick disconnect on hand shower units
-QD
White vinyl hose in place of metal hose
-R
Rebuild trim kit
-REB-TRM
-REV
Reverse coring, hot on right, cold on
left, for back to back installations
-SS
Slip spout on any tub/hand shower unit
-STN
Satin Nickel finish
-T724
24" slide / grab bar with ADA hand
shower in place of standard hand show-
er unit
-T736
36" slide / grab bar with ADA hand
shower in place of standard hand show-
er unit
-TRM
Trim only, valve not included
-X
Integral service stops - allows water
shutoff at valve for service
Note: Append appropriate -suf x to model number.
Identity
Specification
6703
Hand shower system powered by the Temptrol
balancing valve. Features adjustable stop screw to limit
handle turn, wall ell, in-line vacuum breaker, 60" exible
metal hose, hand shower cradle, 1 mode hand shower and
standard 2.5 gpm (9.5 L/min) ow restrictor. Components
made from metal and nonmetallic materials, plated in
standard polished chrome nish.
6704
Tub/hand shower system powered by the Temptrol
pressure-balancing valve. Features adjustable stop screw
to limit handle turn, diverter tub spout, wall ell, in-line
vacuum breaker, 60" exible metal hose, hand shower
cradle, 1 mode hand shower and standard 2.5 gpm
(9.5 L/min) ow restrictor. Components made from metal
and nonmetallic materials, plated in standard polished
chrome nish.
Compliance
-ASME A112.18.1/CSA B125.1
-WaterSense 1.5 gpm (5.7 L/min)
For California Residents
WARNING: This product contains chemicals known to the
State of California to cause cancer, birth defects, or other
reproductive harm.
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
2.0 gpm (7.6 L/min)
®
pressure-
®
Certi ed by
CSA Group

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Symmons Identity 6703

  • Página 1 Limited Lifetime - to the original end purchaser in shower in place of standard hand show- consumer/residential installations. er unit 5 Years - for industrial/commercial installations. Refer to www.symmons.com/warranty for complete  -T736 36" slide / grab bar with ADA hand warranty information.
  • Página 2 Dimensions Measurements Male 1/2" NPT tting must be recessed 1/4" (6 mm) from nished wall 3-1/2", 89 mm 2-7/8", 73 mm Shower Valve Hole Size Min. Ø 3", 76 mm Max. Ø 4", 102 mm 3-1/2", 89 mm Rough-in 2-3/8" ± 1/2", 60 mm ± 13 mm 12", 305 mm Male 1/2"...
  • Página 3: Parts Breakdown

    Parts Breakdown Replacement Parts Item Description Part Number Hand Shower EF-100* Wall Ell EF-105* Set Screw Mounting Plate Wall Cradle EF-106* Screws Vacuum Breaker EF-104* 60" Hose Handle RTS-084* Set Screw Dome Cover T-19* Escutcheon Water Supply Screws 6700-ESC* Mounting Plate COLD Tub Spout 054*...
  • Página 4 Installation Note: 4) Install shower handle (I) to shower 7) Place mounting plate (C) in For valve body installation, please valve. Secure shower handle with position, mark and drill 3/16" holes see valve body manual. set screw (J). for tile anchors (P1), 5/16" holes for drywall anchors (P2).
  • Página 5: Troubleshooting Chart

    Finish is spotting. water staining on nish. non-abrasive cleaner and then quickly rinse with water. Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Phone: (800) 796-6667 Fax: (800) 961-9621 Copyright © 2017 Symmons Industries, Inc. symmons.com gethelp@symmons.com ZV-3197 REV B 021617...
  • Página 6: Modificaciones

    5 años - para instalaciones industriales y comerciales. -T724 Barra agarradera/deslizante de 24” con  Consulte www.symmons.com/warranty para obtener ducha de mano ADA en lugar de la unidad de información más completa sobre la garantía. ducha de mano estándar -T736 Barra agarradera/deslizante de 36”...
  • Página 7: Dimensiones

    Dimensiones Medidas La rosca macho NPT de 1/2” debe estar empotrada a 1/4” (6 mm) de la pared terminada 3-1/2”, 89 mm 2-7/8", 73 mm Tamaño de los ori cios de la válvula para ducha Mín. Ø 3”, 76 mm Máx.
  • Página 8: Desglose De Piezas

    Desglose de piezas Repuestos Número Artículo Descripción de la pieza Ducha EF-100* de mano Codo de pared Tornillo de EF-105* presión Placa de montaje Soporte de EF-106* pared Tornillos Igualador de presión EF-104* Manguera Suministro de 60” de agua CALIENTE Manija Tornillo de RTS-084*...
  • Página 9: Instalación

    Instalación Nota: 4) Instale la manija de la ducha (I) en 7) Coloque la placa de montaje (C) la válvula de la ducha. Sujete la Para instalar el cuerpo de la válvula, en su posición, marque y taladre manija de la ducha con el tornillo vea el manual de la válvula.
  • Página 10: Funcionamiento (Control De Temperatura)

    Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Teléfono: (800) 796-6667 Fax: (800) 961-9621 Copyright © 2017 Symmons Industries, Inc. symmons.com gethelp@symmons.com ZV-3197 REV B 021617...
  • Página 11 5 ans – pour des installations commerciales et -T724 Barre coulissante / d'appui de 24 pouces  industrielles. Se reporter au site www.symmons.com/ avec douche à main ADA au lieu de l'unité de warranty pour des informations complètes concernant douche à main standard la garantie.
  • Página 12 Dimensions Mesures Raccord NPT 1/2 po mâle doit être encastré à 1/4 po (6 mm) du mur ni 3-1/2 po, 89 mm 2-7/8 po, 73 mm Taille du trou pour la vanne de douche Min. Ø 3 po, 76 mm Max.
  • Página 13: Liste Des Pièces

    Liste des pièces Pièces de rechange Numéro Article Description de pièce Douche à main EF-100* Coude mural EF-105* Vis de pression Plaque de montage Support mural EF-106* Brise-vide EF-104* Tuyau de 60 po Assemblage RTS-084* Vis de pression Couvercle en dôme T-19* Alimentation Rosace...
  • Página 14 Installation Remarque : Pour l'installation du 4) Installez la poignée de douche 7) Placez la plaque de montage corps de vanne, veuillez consulter le (I) à la vanne de douche. Fixez la (C) en position, marquez et manuel du corps de vanne. poignée de douche avec les vis de percez des trous de 3/16 po pression (J).
  • Página 15 à l'eau. Symmons Industries, Inc. 31 Brooks Drive Braintree, MA 02184 Téléphone : (800) 796-6667 Télécopieur : (800) 961-9621 Copyright © 2017 Symmons Industries, Inc. www.symmons.com gethelp@symmons.com ZV-3197 REV B 021617...

Este manual también es adecuado para:

Identity 6704

Tabla de contenido