Symmons Identity 6705 Manual De Operación Y Mantenimiento página 5

Installation
9) Place mounting plate (C) in
position, mark and drill 3/16" holes
for tile anchors (T1), 5/16" holes
for drywall anchors (T2). Install
anchors.
T1
T2
C
Note: For dry wall 1/2" thick or less,
insert anchor tool (T3) into drywall
anchor (T2) to secure behind wall
prior to installing wall cradle.
Operation (Temperature Control)
1) Turn shower handle counter-
clockwise approximately 1/4 turn
to put valve in cold position.
Operation (Diverter Control)
1) Cartridge is factory set to divert to
function 1.
Note: Additional handle positions for same output are illustrated.
10) Remove cover of hand shower
cradle (E). Install cradle and
mounting plate (C). Secure with
three screws (F). Replace cover
on hand shower cradle.
T2
T3
2) Turn shower handle counter-
clockwise approximately 1/2 turn
to put valve in warm position.
2) Turn handle to position 2 to divert
to function 2.
E
C
F
5
11) Attach vacuum breaker (G) to wall
ell (B). Attach hose (H) to vacuum
breaker. Attach hand shower (A)
to hose (H). Turn clockwise to
tighten.
3
B
1
G
2
H
5
3) Turn shower handle counter-
clockwise approximately 3/4 turn
to put valve in hot position.
3) Turn handle to position 3 to share
functions 1 and 2.
A
4
H