Installing/Removing The Battery Pack - EGO ED0800 Manual Del Operador

3. Move the guide wheel, along the
depth-adjusting guide bar, up to
increase the depth of cut or down to
decrease the depth (Fig. 5).
The correct depth of cut depends on the
unevenness of the ground, your height,
and the way you hold the edger. Use the
following procedures:
4. Adjust the guide wheel so that the
blade just touches the ground or
breaks the surface of the soil
(Fig. 6).
5. Tighten the depth-adjusting knob
clockwise securely, in the direction
of the locking arrow marked on the
knob.
6. Standing in the normal working
position, check the depth of cut
again and correct it if necessary.

INSTALLING/REMOVING THE BATTERY PACK

WARNING:
assembling parts, making adjustments, cleaning, or when not in use. Removing the
battery pack will prevent accidental starting that could cause serious personal injury.
NOTE: Fully charge the battery pack
before first use.
To install (Fig. 7)
1. Align the ribs of the battery pack
with the mounting slots in the edger.
2. Slide the battery pack in until it
snaps into position.
NOTE: Make sure that the latch on the
bottom of the battery pack snaps in place
and the battery pack is secured to the tool before beginning operation.
Always remove the battery pack from the product when you are
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
5
To Increase Depth
To Decrease Depth
Depth-adjusting Guide Bar
6
7
Mounting Slot
Guide
Wheel
Blade
Rib
17