Maintenance; General Maintenance; Replacing The Blade - EGO ED0800 Manual Del Operador

MAINTENANCE

WARNING:
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician.
WARNING:
therefore, they are always in operating condition. To prevent serious personal injury,
take extra precautions and care when performing maintenance, service, or for changing
the cutting attachment or other attachments.
WARNING:
edger before servicing, cleaning, changing add-on attachments, or when the product is
not in use.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use a clean cloth to remove dirt, dust, oil, grease, etc.
WARNING:
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic, which may result in serious personal injury.
WARNING:
All edger service, other than the items listed in these maintenance instructions, should
be performed by competent service personnel.

REPLACING THE BLADE

WARNING:
a blade may break and it must be replaced. We recommend replacement only with an
EGO edger blade.
NOTICE: Replace the blade if its length is no longer sufficient to maintain the necessary
ground clearance and obtain the required depth of cut.
When servicing, use only identical replacement parts. Use of any
Battery tools do not have to be plugged into an electrical outlet;
To prevent serious personal injury, remove the battery pack from the
Do not at any time let brake fluids, gasoline, petroleum-based
When cleaning the edger, DO NOT immerse in water or other liquids.
Do not attempt to straighten or weld a bent or cracked blade. Such
56V LITHIUM-ION CORDLESS EDGER — ED0800/ED0800-FC
21