Quick Start - Monosem CS 1200-12 Manual Original

- Using and
- To change a setting highlight the setting and change using
changes with and change it using
2.1 – PROGRAMME THE
SENSOR CONSTANT
1 – Position two markers in the field
122 m apart.
2 – Highlight
3 – With the seeder on the ground
move at 6 km/h
4 – When passing the first marker
press .
5 – When passing the second marker
press again.
6 – Repeat the operation when
returning to confirm
FACTORY DEFAULT: 180
(for radar see instructions)
CS 1200-12 – Quick Start
highlight the required icon and press
. Once the required setting has been found press
2.2 – PROGRAMME THE
SEEDER CONFIGURATION
Set the number of rows
Set the distance between rows
Press to return to the main
programming menu
Press
Switch on
1 –
After a few seconds the user menu appears
2 – PROGRAMMING
Press up to programming and
2.1
2.2
2.3
.
and press
again to return to the main user menu
- 57 -
. Highlight the figure to be
.
2.3 – PRIOGRAMME THE
ALARM THRESHOLDS
Set the high and low thresholds in %
High threshold : +10%
Low threshold : - 10%
Press to return to the man
programming menu