Di4 SteamClean Multi10 Manual De Instrucciones página 15

INSTRUCTIONS FOR USE
Assembly
Attaching the handle
Slide the handle into the extension tube until it locks into position.
Slide the extension tube with the handle installed in to the steam mop body until it locks into place.
The handle can be removed from the steam mop body for easy storage by pressing the handle tube button.
Attaching the Steam Head
Slide the button end of the steam mop body onto the triangle mop head until the triangle mop head spindle locks into
place. Hold both parts of the unit and gently push the clip into the handle. This will lock the two parts into position.
Warning: Never force the steam mop body onto the triangle mop head, as this could potentially damage the steam
mop. Always attach the triangle mop head using both hands, ensuring it locks into place correctly.
The triangle steam head can be removed from the main body by pressing the button on the triangle steam head
spindle.
Attaching a Microfibre Cloth
Position the microfibre cloth onto the triangle steam head and secure it with the velcros.
Attaching the Carpet Glider
Position the microfibre cloth into the triangle steam head and place the carpet glider over and around the microfibre
cloth. To remove, simply push the carpet glider by foot
Operation Instruction
1. Fill water
Please kindly fill water before use. Use the measuring cup and funnel to fill water into the water tank.
Please make sure that no residual water in the water tank before adding water. Pour out the rest water after finish
using and clean the boiler. There will be calcification inside which may clog the steam after long time.
For cleaning the water tank firstly add small amount of water in the boiler, fully shaking hands rock the machine,
and than pour out the water completely. Suggest you can repeat above action if the water contains a lot of impurity.
Please close water tank cover when water filled.
Do not inject any liquid except clean water. Never place de-scaling, aromatic, alcoholic or detergent
products in the steam mop tank, this will cause damage to the appliance and void your warranty.
2. Power on
Please ensure that water tank is filled with water and the water tank cover is in a tight status before power on.
Put the plug into socket and open the power switch. If the power is on, the green light will on.
Note that there could be some water coming out at first time as of condensate in the pipe. It will be dry after a few
seconds.
Do not use wet hand to touch the power
Do not use any power cord & socket in broken status.
3. Operation
Using the Steam Mop
Plug the appliance into the mains power supply and switch on. After about 10 seconds the product is ready for
steam cleaning. Steam will run continuously until turn off or the unit runs out of water.
A full tank will supply approximately 12 minutes of steam. If the water tank is empty, the pump will be little pumping
noise and shake, switch must be turn off immediately and refill the water tank following the instructions above.
Using as a Hand-held Steamer
Press the handle tube button to remove the handle from the steam mop body.
15