Empire S-5000 Manual Del Usuario página 8

remote control:
"Source" button:
The "Source" button is used to choose the audio input in use: the
available inputs are "3.5mm", "RCA", and "balanced XLR". The
choice is shown on the front of the system by a group of blue leds.
The left LED indicates the balanced input with XLS connectors.
The center LED indicates the RCA connector input.
The right LED indicates the 3.5mm jack connector input.
"Standby" button:
The Standby button is used to put the audio system in standby:
the system will absorb only a minimal amount of current from the
network.
If you are not planning to use the system for a long time, we sug-
gest using the power switch (G) on the back. When the system is in
"STANDBY", a yellow LED lights up on the front of the system.
"Mute" button:
The Mute button is used to bring the volume to zero. Pressing it
again will restore the previous volume level.
When the "MUTE" function is activated, a red LED lights up on the
front of the system.
"Volume +" and "Volume -":
Press these buttons to raise and lower the volume of the system.
The change in volume will affect all inputs.
Every increase in volume will be shown by a LED flashing on the
front of the system.
8
English