Sunex Tools 66035 Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROPER STORAGE
It is recommended that this jack be stored in a dry location with all wheels touching the ground on a relatively level surface.
TROUBLESHOOTING
Important: Service jacks are self-contained devices used for lifting, but not sustaining, a partial vehicular load. In accordance with
ASME-PALD standard, section 10-4.1.2 Load Sustaining Test: "A load not less than the rated capacity...shall not lower more than 1/8"
(3.18mm) in the first minute, nor a total of .1875" (4.76mm) in 10 minutes." Leak down within this range is considered normal opera-
tion and is NOT a warrantable defect.
LIMITED WARRANTY:
SUNEX INTERNATIONAL, INC. WARRANTS TO ITS CUSTOMERS THAT THE COMPANY'S SUNEX TOOLS
BRANDED PRODUCTS ARE FREE FROM DEFECTS IN WORKMANSHIP AND MATERIALS.
Sunex International, Inc. will repair or replace its Sunex Tools ® branded products which fail to give satisfactory service due to defective workmanship or
materials, based upon the terms and conditions of the following described warranty plans attributed to that specific
product.
This product carries a ONE-YEAR warranty. During this warranty period, Sunex Tools will repair or replace at our option any part or unit which proves to be
defective in material or workmanship.
Other important warranty information...
This warranty does not cover damage to equipment or tools arising from alteration, abuse, misuse, damage and does not cover any repairs or replacement
made by anyone other than Sunex Tools or its authorized warranty service centers.
The foregoing obligation is Sunex Tools' sole liability under this or any implied warranty and under no circumstances shall we be liable for any incidental or
consequential damages.
Note: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Return equipment or parts to Sunex Tools or an authorized Sunex hydraulic warranty center, transportation prepaid. Be certain to include your name and
address, evidence of the purchase date, and description of the suspected defect.
If you have any questions about warranty service, please write to Sunex Tools. This warranty gives you specific legal rights and you may also have other
rights which vary from state to state.
Repair kits and replacement parts are available for many of Sunex Tools products regardless of whether or not the product is still covered by a warranty plan.
SHIPPING ADDRESS:
Sunex Tools: 315 Hawkins Rd.
Travelers Rest, South Carolina 29690
66035
SOLUTION
The release valve is not closed. Turn the valve clockwise tightly. If this does not
work, remove handle, lubricate handle receptacle and handle end, then retry.
Low on hydraulic fluid. Refill the jack to the correct level of
hydraulic fluid, using an approved hydraulic fluid or jack oil.
Pump seals or back-up ring may be defective. Clean hydraulic fluid passages,
replace seals and refill hydraulic fluid. (Must be serviced by qualified service
center)
The hydraulic system has trapped air. Open the release valve, pump handle
rapidly (4) full strokes to purge air, close release valve.
Return spring is broken or linkages are binding. Replace spring if broken. Grease
pivot shaft and all lift arm linkages.
Discharge ball is not sealing hydraulic system and oil may be dirty. Manually flush
hydraulic system. Open the release valve, as required, to raise and lower the lift
arm. Manually raise and lower lift arm.
MAILING ADDRESS:
Sunex Tools: P.O. Box 4215
Greenville, South Carolina 29608

®
rev. 2/0/05

Publicidad

Tabla de contenido
loading

Tabla de contenido